New to Motec so still learning the ropes.
Whenever I try to select View Device Config, I get the error below, any idea what's causing this ?
View Device Config
4 posts
• Page 1 of 1
View Device Config
by tcbandituk on Wed Jul 11, 2012 5:49 am
- Attachments
-
- Motec1.jpg (11.19 KiB) Viewed 12743 times
- tcbandituk
- Posts: 3
- Joined: Thu Jun 28, 2012 11:32 pm
Re: View Device Config
by JamieA on Mon Jul 16, 2012 10:58 am
do you have the latest i2 installed?
do you also have the latest version of the softwre it is trying to open also installed (assuming m84 ECU manager?)
-Jamie
do you also have the latest version of the softwre it is trying to open also installed (assuming m84 ECU manager?)
-Jamie
- JamieA
- Posts: 454
- Joined: Wed Apr 30, 2008 3:16 pm
- Location: Melbourne, Australia
Re: View Device Config
by tcbandituk on Mon Jul 30, 2012 6:32 am
Latest version of i2 installed and firmware is 1.10N
Tried reinstalling but still get the same......
Tried reinstalling but still get the same......
- tcbandituk
- Posts: 3
- Joined: Thu Jun 28, 2012 11:32 pm
Re: View Device Config
by tcbandituk on Mon Jul 30, 2012 7:04 am
Did a bit of rootling around on the PC (registry etc) before finally sussing it, it was fairly straight forward in the end. 
Just need to go to the i2 properties- compatibility and change the privilege level to run it as an administrator
Just need to go to the i2 properties- compatibility and change the privilege level to run it as an administrator
- tcbandituk
- Posts: 3
- Joined: Thu Jun 28, 2012 11:32 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 6 guests