Is it just a matter switching a digital input (dig 1~4) to 0 volts Aux power and configuring the input value to 11
"logging enable".
Could not find anything about here.
Confirmation or condemnation of this appreciated.
Data logging switching
3 posts
• Page 1 of 1
Data logging switching
by Mr ganbatte on Fri Mar 30, 2012 12:30 am
Need to switch on data logging at certain times.
Is it just a matter switching a digital input (dig 1~4) to 0 volts Aux power and configuring the input value to 11
"logging enable".
Could not find anything about here.
Confirmation or condemnation of this appreciated.
Is it just a matter switching a digital input (dig 1~4) to 0 volts Aux power and configuring the input value to 11
"logging enable".
Could not find anything about here.
Confirmation or condemnation of this appreciated.
- Mr ganbatte
- Posts: 13
- Joined: Fri Nov 13, 2009 6:28 pm
Re: Data logging switching
by 20B on Fri Mar 30, 2012 10:44 am
Correct.
It's also best practice as you mention to wire to aux 0 volt pin on the ecu as you don't always get 0 volt when going to earth on the chassis.
It's also best practice as you mention to wire to aux 0 volt pin on the ecu as you don't always get 0 volt when going to earth on the chassis.
Mazda 1993 RX7
20B N/A engine
Motec M800,CDI, SDL, SLM, LTC, DHB
20B N/A engine
Motec M800,CDI, SDL, SLM, LTC, DHB
-
20B - Posts: 140
- Joined: Wed Jan 21, 2009 11:18 am
3 posts
• Page 1 of 1
Return to M400, M600, M800 and M880 ECUs
Who is online
Users browsing this forum: No registered users and 18 guests