Evo 9 boost control
4 posts
• Page 1 of 1
Evo 9 boost control
by jurgen on Wed Sep 17, 2008 6:02 am
I have problems by setting up a PID boost control on an evo9. car doesnt make more boost dan 1.6 bar. wich jet do i have to yuse and what pid corrections??? anyone a base map for that??
- jurgen
- Posts: 14
- Joined: Mon Sep 15, 2008 6:13 am
Re: Evo 9 boost control
by Mazi on Wed Sep 17, 2008 8:42 am
If you have two boost control solenoids jet should be 0.9 or 1.0mm bore and 7mm long. With single solenoid 1.2 mm.
With two solenoids you have to check if pins 41 and 63 are linked together. Try to run ign3 output test (DO NOT FORGET TO DISCONNECT IGNITION COILS FIRST!) and try to find out which solenoid is making sound. If both boost control solenoids are disconnected there must be no sound around engine during ign3 output test. Sometimes........
Are you running v3.4x firmware or previous version?
MAP or MAF controlled?
With two solenoids you have to check if pins 41 and 63 are linked together. Try to run ign3 output test (DO NOT FORGET TO DISCONNECT IGNITION COILS FIRST!) and try to find out which solenoid is making sound. If both boost control solenoids are disconnected there must be no sound around engine during ign3 output test. Sometimes........
Are you running v3.4x firmware or previous version?
MAP or MAF controlled?
-
Mazi - Posts: 146
- Joined: Thu Jul 24, 2008 8:45 pm
Re: Evo 9 boost control
by Mazi on Sat Sep 20, 2008 9:50 pm
Jurgen
Send me your email address on PM.
Send me your email address on PM.
-
Mazi - Posts: 146
- Joined: Thu Jul 24, 2008 8:45 pm
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest