Hi all new member here.
A couple of questions regarding my PLM.My display light flickers on and off but doesnt stay on.I have checked the software settings (95%) and no good.I know the light works but its off most of the time.
Also is the cable available for flashing the firmware or is it easy to make one up?
Cheers....maz
Display light
3 posts
• Page 1 of 1
Display light
by monaro308 on Tue Sep 09, 2008 8:24 pm
- monaro308
- Posts: 2
- Joined: Mon Sep 08, 2008 8:36 pm
Re: Display light
by RossB on Wed Sep 10, 2008 10:11 am
Do you have a good power supply to the PLM? If the power supply is not good the backlight will flicker.
The firmware is not up-gradable in the field, the PLM has to be returned to MoTeC for upgrading. There is no charge for this, you just need to organise it through your MoTeC dealer. The backlight operation could be checked at the same time.
The firmware is not up-gradable in the field, the PLM has to be returned to MoTeC for upgrading. There is no charge for this, you just need to organise it through your MoTeC dealer. The backlight operation could be checked at the same time.
- RossB
- Posts: 474
- Joined: Thu May 01, 2008 2:57 pm
Re: Display light
by monaro308 on Wed Sep 10, 2008 10:18 pm
Ahh ok thanks for that info Ross i will get it organised.
Cheers....thanks MAZ
Cheers....thanks MAZ
- monaro308
- Posts: 2
- Joined: Mon Sep 08, 2008 8:36 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest