M48 question
3 posts
• Page 1 of 1
M48 question
by esvilopez on Wed May 11, 2011 6:24 am
HI I'M NEW HERE i post this thread on the wrong section AND I HAVE A QUESTION I HAVE A 95 TOYOTA SUPRA TT AND MY TRANSMISSION IS AUTO, WILL I BE ABLE TO USE A M48 SINCE IT WAS INSTALLED ON A SUPRA BUT IS A 6 SPEED THANKS FOR THE HELP
- esvilopez
- Posts: 3
- Joined: Sat May 07, 2011 4:36 am
Re: M48 question
by MarkMc on Wed May 11, 2011 3:48 pm
The M48 will need and ignition expander as well to run a 2JZ as it only has 2 ignition outputs as standard.
In a car like that I would say it will need to be piggy-backed to allow the factory engine ECU to keep the automatic gearbox controller happy.
In a car like that I would say it will need to be piggy-backed to allow the factory engine ECU to keep the automatic gearbox controller happy.
- MarkMc
- Posts: 589
- Joined: Thu May 01, 2008 1:28 pm
Re: M48 question
by esvilopez on Thu May 12, 2011 3:58 am
MarkMc wrote:The M48 will need and ignition expander as well to run a 2JZ as it only has 2 ignition outputs as standard.
In a car like that I would say it will need to be piggy-backed to allow the factory engine ECU to keep the automatic gearbox controller happy.
I have the ingnition expander and a pnp harness for the supra
- esvilopez
- Posts: 3
- Joined: Sat May 07, 2011 4:36 am
3 posts
• Page 1 of 1
Return to M4 and M48 ECUs (including M2R and MLS variants)
Who is online
Users browsing this forum: No registered users and 6 guests