PDM32 Programming Loom

Discussion and support for MoTeC Power Distribution Modules

PDM32 Programming Loom

Postby rdmahurin on Wed Mar 23, 2011 6:31 am

I'd like to build a basic programming loom to configure my spare PDM32 away from the car;


Connector A
A_10 CAN Low ->UTC 4
A_11 CAN High -> UTC 5

Connector B
B_b Batt–
B_c Batt–

Connector C
C_1 Batt+

Are these the only connections I need to make to program it?

TIA
rdmahurin
 
Posts: 19
Joined: Tue Jan 18, 2011 2:37 am

Re: PDM32 Programming Loom

Postby JamieA on Tue Mar 29, 2011 4:25 pm

yes, that is all you will need.

regards

Jamie
JamieA
 
Posts: 454
Joined: Wed Apr 30, 2008 3:16 pm
Location: Melbourne, Australia

Re: PDM32 Programming Loom

Postby rdmahurin on Mon Feb 20, 2012 2:58 am

The schematic for the chassis loom I have that interfaces with the PDM 32 also has a ground connected to Pin 1 on the UTC - is this necessary as well?
rdmahurin
 
Posts: 19
Joined: Tue Jan 18, 2011 2:37 am

Re: PDM32 Programming Loom

Postby JamieA on Tue Feb 21, 2012 4:31 pm

Power for the PDM,
CAN Hi and CAN Lo for the UTC are all that you need.

regards,

-Jamie
JamieA
 
Posts: 454
Joined: Wed Apr 30, 2008 3:16 pm
Location: Melbourne, Australia


Return to PDM15 PDM16 PDM30 and PDM32

Who is online

Users browsing this forum: No registered users and 13 guests