Can someone explain how to wire up a 10 bar VDO pressure sensor to auxiliary temp input 4 on an M800 ecu ?
There appears to be a calibration table for it in the setup screen but no explanation of the wiring other than connection to an ADL in the vdo diagram.
Aux temp input VDO pressure calibration
3 posts
• Page 1 of 1
Aux temp input VDO pressure calibration
by 20B on Thu Nov 11, 2010 9:25 pm
Mazda 1993 RX7
20B N/A engine
Motec M800,CDI, SDL, SLM, LTC, DHB
20B N/A engine
Motec M800,CDI, SDL, SLM, LTC, DHB
-
20B - Posts: 140
- Joined: Wed Jan 21, 2009 11:18 am
Re: Aux temp input VDO pressure calibration
by 20B on Fri Nov 19, 2010 7:52 am
Anyone ?
Mazda 1993 RX7
20B N/A engine
Motec M800,CDI, SDL, SLM, LTC, DHB
20B N/A engine
Motec M800,CDI, SDL, SLM, LTC, DHB
-
20B - Posts: 140
- Joined: Wed Jan 21, 2009 11:18 am
Re: Aux temp input VDO pressure calibration
by SprinterTRD on Fri Nov 19, 2010 11:51 am
2 wire VDO or single?
A 2 wire one just connect one terminal to the temp input and the other to 0V. There is a drawing on the site.
A 2 wire one just connect one terminal to the temp input and the other to 0V. There is a drawing on the site.
- SprinterTRD
- Pro User
- Posts: 377
- Joined: Wed Jul 16, 2008 9:24 am
3 posts
• Page 1 of 1
Return to Sensors, Valves and Wiring
Who is online
Users browsing this forum: No registered users and 4 guests