Hi
I’have a question about using PDM 15, M800 and UTC. My M800 is connectet to output xx of the PDM the UTC is connectet to canbus, Aux 8V and Aux 0V of the M800. At the first Startup only the PDM is connectet to Bat. and Ground so the M800 is off. Is it poosibel to configure the PDM without 8V for the M800?
Regards Thorsten
Configure PDM on Startup
4 posts
• Page 1 of 1
Configure PDM on Startup
by thorstengsxr on Mon May 03, 2010 10:32 pm
- thorstengsxr
- Posts: 51
- Joined: Thu Jul 10, 2008 10:00 pm
Re: Configure PDM on Startup
by Martin on Tue May 04, 2010 4:44 pm
Thorsten,
Only the very old can Cables used the 8v. On a UTC the 8v is not needed as the USB port supplies its power
Only the very old can Cables used the 8v. On a UTC the 8v is not needed as the USB port supplies its power
-
Martin - Pro User
- Posts: 640
- Joined: Thu Jul 10, 2008 2:57 am
- Location: Pretoria, Suid Afrika
Re: Configure PDM on Startup
by DarrenR on Thu May 20, 2010 3:10 pm
Yes, the PDM is not compatible with the parallel port CAN Cable for this reason. It is UTC only.
Darren Reynolds
MoTeC Research Centre - Melbourne, Australia.
MoTeC Research Centre - Melbourne, Australia.
- DarrenR
- MoTeC
- Posts: 176
- Joined: Thu May 01, 2008 2:15 pm
- Location: Melbourne, Australia
4 posts
• Page 1 of 1
Return to PDM15 PDM16 PDM30 and PDM32
Who is online
Users browsing this forum: No registered users and 7 guests