by DarrenR on Tue May 11, 2010 2:04 pm
Hi,
You can set your anti-lag button to function 25, ORB Select. This function toggles between ORB off, table set 1, table set 2, and back to off. You may have to change your ORB setup to work this way as it changes the momentry action to a toggling action.
Or alternativle leave the button as it is and add a toggle switch wired the another dig/switch input set to function 24, ORB Table. Then this switch selects which table to use.
You can also setup an output status light, output function 115. You can then select the light to activate for table set 1 and flash for table set 2 to indicate which mode you're in.
Darren Reynolds
MoTeC Research Centre - Melbourne, Australia.