Speed and Dig input opinions.. HELP!

[bazeng]

Hi guys,

I'm just wondering if I can get all these 3 inputs onto the SDL?

We only have 2 Speed inputs and 2 dig inputs. I plan to use wheel speed 1 on a front wheel (wheel speed), and wheel speed 2 on the Tailshaft.

I then have a pulley which I plan to use for picking up RPM.
It is a GT101 sensor reading a pulley off the crank. The only thing is that it is an alloy pulley with holes drilled into it, which were tapped and then 2 magnet screwed in which were then shaved flush. The GT101 sensor is a hall effect sensor. The sensor has 3 wires - 8v, gnd and sensor.

Anyway, my plan is to run the tailshaft and wheelspeed on the speed inputs. Can I use the dig input with the pulley for RPM?

Btw, its a carby motor.

Thanks
Baz

[IDP]

Should be no problem at all.

[bazeng]

OK,

I believe the GT101 sensor is ok to run on a DIG input.
The other 2 should be ok on the speed input.

I managed to find some documentation on the sensors.

[JamieA]

yeh, that will be fine.