Displaying Speed without 1 decimal ( ECU Manager )

[PWCGUY]

I would like to display speed in ECU manager using a dial gauge without any decimal points. Don't need the culter of every value on the gauge shown with ".0". The dail gauge itself doesn't seem to control this and apartently relies on the calibration of the speed sensor input. So looked at the calibrations under sensor setup both predefined and custom and they all included one decimal point and could not redefined to eliminate the decimal place. Application is a PWC with a water paddle wheel that is connected to a digital input. Is there a way to define a new calibration either custom or predefined without using one decimal place for a digital speed input ?

[IDP]

Try using a User channel and selecting custom calibration, Unitless No DP

[PWCGUY]

That works !

Thanks
Mike D.