Hi, Mates!
Whether can share parametres for CAM control outputs? At me the engine of BMW M62 with double VANOS (on inlet CAMs).
PID gains, frequency and Hi/Lo limits interested.
It is in advance grateful
-Andrey
MoTeC M800 - VANOS settings needed
3 posts
• Page 1 of 1
MoTeC M800 - VANOS settings needed
by AVF on Tue Nov 10, 2009 7:43 am
- AVF
- Posts: 5
- Joined: Fri Nov 06, 2009 4:50 pm
Re: MoTeC M800 - VANOS settings needed
by 48DZI on Mon Dec 14, 2009 2:35 am
Hello,
Here is my file,
I hope to get it re-mapped with a different guy in the next few weeks ans will send on the new file then
Regrads
Here is my file,
I hope to get it re-mapped with a different guy in the next few weeks ans will send on the new file then
Regrads
- Attachments
-
m3.e35- (72 KiB) Downloaded 1257 times
- 48DZI
- Posts: 5
- Joined: Sat Nov 21, 2009 5:50 am
Re: MoTeC M800 - VANOS settings needed
by AVF on Mon Dec 14, 2009 4:51 am
Tnank you !
But i have one wire controlled electromagnetic valve and have to use Cam Control 1 mode.
Integraд and derivative gains are equal in your calibration to zero that , I consider, incorrectly.
-Andrej
But i have one wire controlled electromagnetic valve and have to use Cam Control 1 mode.
Integraд and derivative gains are equal in your calibration to zero that , I consider, incorrectly.
-Andrej
- AVF
- Posts: 5
- Joined: Fri Nov 06, 2009 4:50 pm
3 posts
• Page 1 of 1
Return to M400, M600, M800 and M880 ECUs
Who is online
Users browsing this forum: No registered users and 15 guests