I have been getting used to the m4 software before install of ecu.
My problem is a have some how set the rpm site so it only goes up to 1490rpms, how can i set this to 8500rpm at 250 0r
500 rpm increments?
Thank you
rpm site m4
3 posts
• Page 1 of 1
rpm site m4
by abs on Wed Nov 11, 2009 9:59 pm
Hi
I have been getting used to the m4 software before install of ecu.
My problem is a have some how set the rpm site so it only goes up to 1490rpms, how can i set this to 8500rpm at 250 0r
500 rpm increments?
Thank you
I have been getting used to the m4 software before install of ecu.
My problem is a have some how set the rpm site so it only goes up to 1490rpms, how can i set this to 8500rpm at 250 0r
500 rpm increments?
Thank you
- abs
- Posts: 3
- Joined: Sun Aug 16, 2009 10:50 pm
Re: rpm site m4
by bx7 on Wed Nov 18, 2009 5:48 am
Hi.
you can change this in site setup, RPM Sites. You can give value of RPM you want...
you can change this in site setup, RPM Sites. You can give value of RPM you want...
- bx7
- Posts: 8
- Joined: Sat Nov 07, 2009 12:15 am
3 posts
• Page 1 of 1
Return to M4 and M48 ECUs (including M2R and MLS variants)
Who is online
Users browsing this forum: No registered users and 4 guests