Hello¡¡¡
Could i build a CAN INTERFACE CABLE?
Parallel to NEUTRIK connector or Parallel to d9.
Thank
Build CAN INTERFACE CABLE
3 posts
• Page 1 of 1
Build CAN INTERFACE CABLE
by Aljiru on Tue Apr 21, 2009 7:18 am
- Aljiru
- Posts: 5
- Joined: Fri Feb 27, 2009 9:01 am
Re: Build CAN INTERFACE CABLE
by DarrenR on Tue Apr 21, 2009 1:09 pm
The Motec CAN cable has quite a bit of circuitry in the parallel connector shell so it is not possible to build one with out this interface circuit board.
Regards,
Regards,
Darren Reynolds
MoTeC Research Centre - Melbourne, Australia.
MoTeC Research Centre - Melbourne, Australia.
- DarrenR
- MoTeC
- Posts: 176
- Joined: Thu May 01, 2008 2:15 pm
- Location: Melbourne, Australia
Re: Build CAN INTERFACE CABLE
by figgie on Fri May 15, 2009 2:37 am
aljiru
to add to Darren's post.
CAN is a serial interface with a serial transmission. What you are proposing is basically sending a serial stream into a parallel system that uses parallel data information. Not a simple task of doing that without adding a serial-parallel convertor in the middle and not any serial stream, CANbus.
Look at the older printers that had a serial AND parallel port on it. Not very easy way to go between both.
to add to Darren's post.
CAN is a serial interface with a serial transmission. What you are proposing is basically sending a serial stream into a parallel system that uses parallel data information. Not a simple task of doing that without adding a serial-parallel convertor in the middle and not any serial stream, CANbus.
Look at the older printers that had a serial AND parallel port on it. Not very easy way to go between both.
- figgie
- Posts: 135
- Joined: Fri Jul 11, 2008 4:22 am
- Location: Minnesota, USA
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 16 guests