ADL2 with M1..no data ?

[Merlin]

Hi All

This one has me beat

Car has
M130
ADL2
Pdm 15
LTCD
15 button keypad

All works fine
Just no ECU Data in dash

I can see LTCD and PDM values in ADL2 so CAN bus is working fine with those
I set up a C125 on loom and have ECU values in it no problem.. so car loom is fine and ECU is transmitting

Have checked CAN rate ..all set to 1M
Have compared C127 and ADL2 CAN templates and all seem the same

If you have any other thoughts please post them up

John P

[Merlin]

Update

solved

moved Can template M1General_640 to a receive input only and all works fine


go figure that ?????


John P

[NathanB]

Hi John,

Glad you got it sorted. Yes this is correct. Receive block templates only work in receive only slots. Receive block is not an accepted device type in the templates for Rx/Tx can slots in ADL2 manager

Regards,

Nathan