Subaru 2007 Ref Sync needed

[ammar.alqisie30]

3 Captures attached, which one looks good ?

[Stephen Dean]

Capture three is showing the correct signals and voltages. The Inlet Camshafts are on UDig 4 and Udig 5 in the capture.

[ammar.alqisie30]

Sounds good, it should be raising , pullup on?

And whats the correct offset and calibration?

[Stephen Dean]

Hi,

I would use the settings for the MY08+

[ammar.alqisie30]

We used the setup you sent, it keeps giving bad sensor.

Engine is 2007 not 2004. We use the front cam as Engine synchronization pin and the rear for cam inlets bank 1 and bank 2,

I saw some people saying we should use the synchronization pin on back on of them.

Car is runing fine, but problem with AVCS .

Camshafts teeth of 2007 is different with 2004

Any advice? .

[Stephen Dean]

Hi,

I have attached a Input Capture from a Early EJ207 that uses the EJ207AVCS Reference Mode, as this has cams with 4 equally spaced teeth and Mag sensors. You have a 4-1 tooth pattern on your cams, which is used in the FA20D Reference Mode. You can disable the Sync input and just use the Inlet Cams.

[ammar.alqisie30]

Attached your capture with our capture to compare, the capture on cam inlets is different.

Check the captured pictures we attached .

[Stephen Dean]

That is correct, My Capture uses the EJ207AVCS Reference Mode with the four evenly spaced Inlet Cam teeth and Mag sensors. Yours uses the FA20D Reference mode with the 4-1 Tooth pattern and Hall sensors.

[ammar.alqisie30]

So, should we change the Engine speed reference mode to FA20D ?

[Stephen Dean]

Yes.