15 Button Keypad wake up on M141

[Tasboost]

Hoping someone might be able to assist me with getting a Motec 15 button keypad to wake up on my M141.
I have Driver keypad enabled and set to CAN bus 1, CAN ID base set to 0x0506 and Node ID set to 0x0a.
I have setup some toggle switches as a test but I get a communications error…

Could it be that the Motec switch panel is operating at a rate of 1000 and CANBus 1-3 are all set to 500 in my ECU (Motec m141 for Toyota GR Yaris) or do I also need to tell the keypad to wake up?

I also have a C125 dash but would prefer to configure the keypad using the m141 as the gateway.

Appreciate any advice you may have.

Many thanks,
Nick

[SOReilly]

Hi Nick,

As supplied the keypads are configured for 1Mbps bitrate.

PDM Manager includes a keypad configuration tool which you can use to change the bitrate and IDs of keypads.

To use the configuration tool you will need a MoTeC UTC to communicate with the keypad.

If you require assistance changing the bitrate of your keypad you should contact the MoTeC dealer that supplied your hardware.