M1 engine speed reference rotax BRP 2 stroke

[valegas]

v6 evinrude g1 300 trigger wheel

triggerwheelevinrudev6.jpg (29.55 KiB) Viewed 3104 times

hello, i'm working on an evinrude v6 2 stroke direct injection engine.
i see i can choose Rotax BRP in my engine speed reference mode tag.
the idea is ok: so a 24+X+X+X trigger wheel.

looking to the description, i see tooth pattern:2 of 7.5°, 9 of 15°, 4 of 7.5°,10 of 15°, s of 7.5°, 1 of 15ç (24+2+1+1)
or on my engine the idea is the same but on my v6 i have: a 24+1+1+1+1+1. distances 15° or 7.5° are correct.

[img]

triggerwheelevinrudev6.jpg

g[/img]

is it possible to obtain this refefence mode for my M1 series? what dev license i must buy?
thanks

[Stephen Dean]

Hi,

Do you have an Input Capture for this engine?

Development licences do not allow for the creation of custom Reference Modes, these are done at a much lower level in the M1 Architecture and can only be done by MoTeC.

For this work you are better off emailing [url=support@motec.com.au]MoTeC Support[/url] directly.