Display change from keypad buttons

[NAVSENG]

I am having trouble making a page up and page down function work from my keypad to the c125. I think part of my issue may be the way I have the button configured. Since there is no output channel like switching on a fan or something like that, I don't see the options on what the button function should be (in PDM manager). What do I do here?

Also not sure how to configure it on the C125 side. I have a config that uses a standard harness with a single button for mode change, is this where I would tell it to use the Keypad button? I didnt see anywhere to differentiate between up / down. I suppose I could to it all with one button if that makes it work

[Stephen Dean]

Hi,

Can you attach your PDM and Dash configuration thanks, there are a number of different ways that this can be done but seeing what is currently configured is needed to point you in the correct direction.

[NAVSENG]

Attatched , still learning so I dont have it all together yet.

[RRB]

I struggle with some of the same problem so nice if you share the solution here






Best regard Ronny

my car has
M400
PDM15
Keypad15
C125

[Stephen Dean]

Hi,

I have created a CAN Transmit out of the PDM into the Dash, this is sending a Page Up and a Next Line message in to the Dash, in the Dash under CAN 1 (presuming that this is where the PDM is wired to) I have added a CAN Receive template for these two channels. I have then used these channels in the Display setup to change the Page Displayed and to scroll through the lines at the bottom of the screen.

I used the latest public release software to edit the files.

[NAVSENG]

Hi,

I have created a CAN Transmit out of the PDM into the Dash, this is sending a Page Up and a Next Line message in to the Dash, in the Dash under CAN 1 (presuming that this is where the PDM is wired to) I have added a CAN Receive template for these two channels. I have then used these channels in the Display setup to change the Page Displayed and to scroll through the lines at the bottom of the screen.

I used the latest public release software to edit the files.

It works but after 30 seconds it goes on continuous loop and changes the page really quickly! Any idea?

[Stephen Dean]

Hi,

Try this, I added a CAN Address conflict in the previous version.