Motec m150 gear position to c127 not working??

[Mobne]

I’m using the protocol provided from motec.

I can’t get the dash to read the gear. It just shows 3 all the time.
The ecu reads it as expected. But nothing in the dash.

The channel in the c127 is just “gear”.

Any ideas?

[Anthony]

check the comms in the dash and that you are receiving the gear channel, its in the comms template "M1 general 0x640"

[Stephen Dean]

Hi,

What Firmware are you running in the M1?

[whrdnsx]

Hello
I have the same problem. The solution wasn't posted.

Gear position reading fine on M150 but not the dash. Version 0.1.11.0203 Tune 1.4

Using the M1 General template. other sensors are working on the dash.

I checked on the dash config it seems that it defaults to ADR for the gear position? can't seem to change to ECU.