CDL3 RS232 serial OUTPUT

[greenamex2]

Hi all

I expect I am about to be very upset but...

Is there any way to OUTPUT a RS232 serial stream from a CDL3?


Was hoping to pick up a stream of some kind into the PC in the car for a Python driven gauges display without duplicating the UTC already attached to it with an after market USB to CAN device (ran out of USB ports).

Thanks in advance

[David Ferguson]

Try Selecting Telemetry Only, then edit the template and change Device to Async TX 1. Modify the ASCII Transmit Setting to add a delimiter and termination. Add some channels and see what you get.

If you're planning to use serial GPS, you'll need to put that on another RS-232 RX

Good Luck.

[greenamex2]

Looks very promising, thanks David.

Will test further when 15 dollar serial cable arrives!