Hello,
is it possible to run the M142 ECU with 24V supply voltage?
Will the voltage regulators inside the ECU lasts this voltage level?
Sensors are supplied by internal 5V/6.3V - so probably not an issue. Same with the low-side outputs as max. voltage is specified with 40/60V here, I think.
Driven DI injectors are of 24V type (inductive). Boost voltage of 90V should be still available with 24V supply, output stage controls current --> so could work anymore, if current level meet the requirements of the injector,
But what's with the full bridge driver to run a DBW unit? Will this work? Is it possible to use a 12V DBW unit?
thanks in advance, Klaus.