Zero the TPS at idle

[Edszx14]

My throttle position sensor shows 1.4% when the engine is idling. How can I zero the throttle position sensor to read 0% at idle. Thanks

[SprinterTRD]

Which ECU do you have?

[Edszx14]

I have the M130. Thanks

[Stephen Dean]

Hi,

When connected to the M130 using M1 Tune, go to the Initial Setup 2 workbook, and then the Throttle Pedal worksheet.

With you foot off of the pedal, select Throttle Pedal Main Offset and press the Q key on your keyboard. This will read the current value on the throttle and apply it to the calibration. Save the changes to force the changes to the M1.

[Edszx14]

Awesome. I will give that a try. Thanks for your help.

[Edszx14]

Hello Mr.Dean. On my M130 I do not have the Throttle Pedal Main Offset available to me. My only selection is called " Driver Throttle Pedal translation Switch". I selected this and then pressed the "Q" on my keyboard but that didn't solve the issue. Any help you can provide it greatly appreciated. Thanks

[Stephen Dean]

Hi,

What is the Firmware that you are running in the M1? If you send me the serial number I can look this up as well.

The Driver Throttle Pedal Translation Switch is a switch that allows for multiple throttle pedal translation tables to be used, this lets the driver tune the relationship between the Throttle Pedal and Throttle Servo (on a DBW system) to be varied in the vehicle by swapping between different maps.

[Edszx14]

Hello,

The serial number is 4861
Firmware - Motorcycle drag race
Firmware version - 01.01.0037


Thanks,

Eddie

[Stephen Dean]

Hi Eddie,

As the Motorcycle Drag Race Package is a custom Package built on an older base than our current Packages, there are some differences in the functionality compared to what I described earlier.

The Parameter that you need to find is Throttle Position Sensor Offset, with the throttle control lever in its resting position, select this Parameter and then press the Q key to set the 0% value on the throttle.

Motorcycle Drag TPS.PNG (9.91 KiB) Viewed 22365 times

[Edszx14]

Hello Mr.Dean,

Thanks for your help. I will give that a try and let you know how it works.

Eddie