SDL Config upload

[WayneMolloy]

I have a SDL , when i upload a config file i get a error message afterwards, the config file does seem to upload but I'm not sure why the message pops up. the error box reads " Send Configuration" , Error reading from device memory operation failed CAN Bus error.
Can someone help

[adrian]

Are you connected to the Dash directly with USB or are you connected via CAN with a UTC?

[WayneMolloy]

I have a UTC connected to the SDL

[adrian]

Is there are reason you are using a CAN connection rather than directly connecting with USB? Does everything work once you have sent the config even though you get the error message?

[WayneMolloy]

Hi Adrian

I have a M84, SLM and a LTC connected to the SDL via CAN with one diagnostic port, i only connect to ECU or SDL.
I am getting Temp and RPM from the ECU but still struggling with the lambda signal (LTC 4.9)

[adrian]

Can you please send me both your M84 and SDL configs, you can send them to me at support@motec.com.au

[WayneMolloy]

Hi Adrian

I have sent you the requested config files, hope it is what you need, thanks