Injector errors in log for M4

[stownsen914]

I recently got a Porsche 968 motor that sat for many years running again. It has the same M4 and map as when it last ran years ago. After a shakedown run at the track a couple weeks ago, I downloaded the logs and found injector errors. In approx. 4.5 minutes of logs, I see a few seconds worth of errors for each injector (injector 4 had the most at 18 seconds worth). The errors seem spread out during the 4.5 minutes. There are also a couple seconds worth of Sync errors in the logs. The EMP diagnostics screen shows OK for each injector. The engine seemed to run fine from a "seat of the pants" standpoint. The injectors are older Bosch units that I had rebuilt while the engine was being rebuilt. I saved the logs from this engine's last run years ago before the car was put in storage, and there aren't any injector errors.

Should I be concerned about injector errors in the logs? Thanks.

Scott

[stownsen914]

I checked the EMP diagnostics again, and it reads OK for all 4 injectors. I also did the injector test for about 30 seconds and didn't notice any issues. And then re-downloaded the logs to see if any new errors show in the logs - there aren't any. This is of course at low duty cycle. Does the engine need to be running to properly test this?

[SprinterTRD]

The only time logging starts is when the engine is running.

If it is a old loom then replace the injector connector pins also have a look at drawing Z05

[stownsen914]

Thank you SprinterTRD. I poked around on the Motec site and googled, and can't find drawing Z05. Where should I look for that?

[David Ferguson]

Here is the Z05 drawing: