cdl3 crashing on warmup tab

[Entranced]

Downloaded my calibration I got from my tuner off the dash and started looking at the screens and I get "unit type not found" message (see attached) and the program crashes.

I contacted my tuner and sent him the calibration file and it opens normally on two of his computers without issue.

Any ideas? Thanks!

[adrian]

Can you please try copying the below file to C:\Program Files (x86)\MoTeC\Common\1.0\Units\en and see if that fixes the problem.

Couple of things to note:
Make sure you close Dash Manager before you copy the file.
If you are asked to override the existing file, click yes.

[Entranced]

replaced the units file with the one you attached but it didn't resolve the fatal error. still crashes only on warmup tab.

[adrian]

Ok, can you please send your config file to support@motec.com.au and I'll take a look at it.