M130 and VR abs wheel speed
3 posts
• Page 1 of 1
M130 and VR abs wheel speed
by Moorespeed on Mon May 22, 2017 5:59 am
Can i use a 2 wire vr wheel speed sensor with my m130 and if so what input do i wire it as or to?
- Moorespeed
- Posts: 5
- Joined: Tue Apr 04, 2017 2:10 pm
Re: M130 and VR abs wheel speed
by Stephen Dean on Mon May 22, 2017 11:05 am
Hi,
You need to supply switched 12V+ to the + pin on the sensor, and then from the - pin on the sensor you wire this to a UDig input, with a bridge through a 220 Ohm resistor to 0V.
This should give you a signal range between 1.6V and 3.6V, so use a Threshold of 2.5V and a Hysteresis value of 0.2V.
You need to supply switched 12V+ to the + pin on the sensor, and then from the - pin on the sensor you wire this to a UDig input, with a bridge through a 220 Ohm resistor to 0V.
This should give you a signal range between 1.6V and 3.6V, so use a Threshold of 2.5V and a Hysteresis value of 0.2V.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
MoTeC Research Centre Melbourne, Australia
-
Stephen Dean - Site Admin
- Posts: 1688
- Joined: Tue Dec 02, 2014 10:29 am
- Location: Melbourne
Re: M130 and VR abs wheel speed
by sphilips on Mon May 29, 2017 5:33 am
can this also be done with the m800? I mean the 2 wire speedsensors wired to the digital inputs?
- sphilips
- Posts: 47
- Joined: Mon May 30, 2011 8:11 am
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 63 guests