MDD

[rems11]

Hi Everybody

I have a probleme with my MDD.

I can't display on MDD drive speed and gear detection, while i have gear dectection and drive speed left with logs on my M800

All others mesures display except drive speed left and gear detection

[JamieA]

Have you verified whilst driving (with a passenger reading the connected laptop) that the "Ground Speed" channel, and the "Gear" channels are definately showing accurate readings?

it has to be those exact channel names...

regards,

Jamie

[rems11]

Jamie

Gear detection is ok

Here my log

[JamieA]

how about the ground speed channel?

Perhaps email me your config so that I can test it here.

Jamie.augustine@motec.com.au

[rems11]

I have sent you my config Jamie, thanks for your help

[OmarK]

Hi,

Your ECU config is fine and is working, can you go for another drive, check if you can see gear and speed working and send us the log file from the ECU so we can take a look further.

[Paragon]

I have the same problem with the gear not displaying but do have speed.

Was there ever a solution to this ?

MDD V1.14 M800 V3.54

[adrian]

I'm not sure what the original issue was but if you send your ECU config to support@motec.com.au I can test it out for you.

[Paragon]

the solution is to get your MDD firmware upgraded. The problem is known and since the upgrade is not as easy as plugging in a UTC the MDD generally does not get upgraded after leaving the factory.

This solved the lack of gear position on my unit and a mates, 2 different old firmwares.