I have a problem, I have climbed on a m800 wrx78 and I have connected a SDC with line Can, unfortunately it doesn't acquire me the data, in the ECU Manager I have planned the Khan setup in the following way:
-Can 1 date: 5
-Can 1 address: 96
-Can 1 transfer Installments: 50
I have made some error or it misses some information
Thanks
m800 for acquisition
2 posts
• Page 1 of 1
m800 for acquisition
by alexflamingo on Sun Oct 19, 2008 6:27 pm
-
alexflamingo - Posts: 16
- Joined: Thu Jul 17, 2008 10:10 pm
- Location: Italy
Re: m800 for acquisition
by DarrenR on Wed Jan 07, 2009 3:13 pm
Hi,
The SDC2 to M800 comms is via RS232 to make use of the factory wiring loom.
For setup follow the instructions on page 19 of the SDC2 manual available here http://motec.com.au/filedownload.php/SDC2%20User%20Manual.PDF?docid=2149
CAN communication from the SDC2 is for connecting to a ADL/2 Dash logger and for programming the SDC2.
Regards,
The SDC2 to M800 comms is via RS232 to make use of the factory wiring loom.
For setup follow the instructions on page 19 of the SDC2 manual available here http://motec.com.au/filedownload.php/SDC2%20User%20Manual.PDF?docid=2149
CAN communication from the SDC2 is for connecting to a ADL/2 Dash logger and for programming the SDC2.
Regards,
Darren Reynolds
MoTeC Research Centre - Melbourne, Australia.
MoTeC Research Centre - Melbourne, Australia.
- DarrenR
- MoTeC
- Posts: 176
- Joined: Thu May 01, 2008 2:15 pm
- Location: Melbourne, Australia
2 posts
• Page 1 of 1
Return to M400, M600, M800 and M880 ECUs
Who is online
Users browsing this forum: No registered users and 17 guests