DUCATI 48-2 mode 60 flywheel

Discussion and support for MoTeC's previous generation ECUs.

DUCATI 48-2 mode 60 flywheel

Postby DGMmoteur on Tue Apr 18, 2017 7:54 pm

Hello,

I'm trying to do the initial setup of this engine, someone has the required wiring for this special trigger mode ?
Is it necessary to connect the sync pin to the ref pin ?

Thank you ! ;)
DGMmoteur
 
Posts: 5
Joined: Sun Apr 16, 2017 2:47 am

Re: DUCATI 48-2 mode 60 flywheel

Postby Auto Sport Elect on Wed Apr 19, 2017 9:14 am

Hello,
Yes you join connect the crank sensor to both Ref and Sync.
They are not the easiest engines to get to sync up, especially if they have a lot of light weight components in the rotating assembly.
Auto Sport Elect
 
Posts: 22
Joined: Tue Jun 12, 2012 1:45 pm

Re: DUCATI 48-2 mode 60 flywheel

Postby DGMmoteur on Sat Apr 22, 2017 12:46 am

Hi !

Thank you for the answer. We have tried several enhancement : make deeper teeths (that's working quite fine), and we have put a hall effect sensor.
DGMmoteur
 
Posts: 5
Joined: Sun Apr 16, 2017 2:47 am

Re: DUCATI 48-2 mode 60 flywheel

Postby Auto Sport Elect on Thu Sep 21, 2017 3:43 pm

Good to hear.
Best upgrade you can make is going to an M1, they start better than a road bike.
The difference on the same bike from a M800 to and M1 is bigger than I can describe. Well worth the investment.
Auto Sport Elect
 
Posts: 22
Joined: Tue Jun 12, 2012 1:45 pm


Return to M400, M600, M800 and M880 ECUs

Who is online

Users browsing this forum: No registered users and 10 guests