Just wondering what people do when it comes to wiring outputs using 2 pins, do they :
a) run two individual wires from each pin on the PDM connector to the device and then then join them at the device or device connector, or
b) run very short wires from each pin on the PDM connector to a splice, and then run a large gauge wire to the device.
c) something else
My intention is to use M22759 Tefzel wire throughout, 22 AWG for switches and CAN bus, 20 AWG for 8 AMP outputs and 16 AWG for the 20 AMP outputs.
Regards
Toby