M800 and E888 - no communication

[timo]

Ah ok, I thought there might be some hidden menu option to check the firmware version.
I run that tool and the progress bar appeared and it finished without errors so I think 2.07 is loaded on the e888.

Also keep in mind PWM 1,3,5,7 have different output properties than 2,4,6 and 8.

I' ve read that in the manual so I started my test with PWM2. At the end I had tested all PWM outputs of the e888 but they were all the same.
I'll keep on tryin'...

[adrian]

Sorry I forgot to mention the transmit addresses are the base address plus 3. You should set your CAN 3 address to 251. Addresses are as follows:

Rx: 0x0F0 - Tx: 0x0F3
Rx: 0x0F4 - Tx: 0x0F7
Rx: 0x0F8 - Tx: 0x0FB
Rx: 0x0FC - Tx: 0x0FF

[Sean]

I made a step into the right direction today thanks to all your help.

Nothing to do with me, that's all Adrian

[timo]

E888 is fully working now. These are the settings which I use. Maybe this is helpful for someone else.

E888_CAN_setup.jpg (32.12 KiB) Viewed 13158 times

Nothing to do with me, that's all Adrian

Sorry, I guess I muddeled up something there But thanks anyway, you also provided help.

Sorry I forgot to mention the transmit addresses are the base address plus 3

Thank you so much for your time and your help Adrian! I really appreciate that. Thanks to you I can finally enjoy the benefits of the e888.

[adrian]

Thank you so much for your time and your help Adrian! I really appreciate that. Thanks to you I can finally enjoy the benefits of the e888.

No problems, I'm glad it's all working now.