Lap Editor Question

[killerbee]

I have been trying to figure out how to remove multiple laps using the lap editor. All I can select is a single lap at a time. Is there a way to do this ?

[adrian]

It is only possible to select one lap at a time. I have added this as a feature request.

[killerbee]

The reason I am asking is that we have had some difficulties with laps generated using a GPS beacon stored in the dash (SDL3). Occasionally, it is clear that the dash generated laps do not correctly show the car's position on the track. It makes a hash of lap comparisons also. The only way I have found to clean things up is delete all the dash generated lap beacons and regenerate them in I2. I must be doing the dash setup wrong but I have watched the webnairs associated with the subject and have followed the instructions.

[adrian]

Are you actually getting beacon points at different parts of the track? When you say 'not correctly showing the cars position on the track' are you looking at a track map or a GPS track map?

The best way to setup the GPS beacons is to first get some logged GPS data from the track. In i2 move the cursor to the start/finish line and then copy the lat/long coords into the venue details of SDL3 Manager.

One other thing to check is that your detection radius is at least 10m.