Lambda reading on C127

[alexmas0n]

Hi,

I just purchased a C127 and was wondering how to wire an LSU 4.9 directly to the dash. I have the I/O upgrade on the dash. Is it possible?

Thank you.

[David Ferguson]

Your LSU 4.9 sensor cannot be wired directly the the dash. It requires a lambda controller (such as the MoTeC Lambda-To-CAN module, the LTC). You would connect an LTC using the CAN bus, plus 12V power wired to your ignition power. You configure the LTC under the communications window.

[FoxSTI]

Alex, you can also look at innovate LC1 or LC2 that is what I have as far as contoller and plan on connect it to my C125 once I get the I/O upgrade.