Ref/sync not Synchronized.

[stevieturbo]

What is wrong is you are uploading images of a capture, not the capture.

Remove all spark plugs except cylinder 1, and crank the engine over and do a capture.

But you do look to have a decent hall effect signal going on there.

[abdo28]

hi 360 wont work try
695 crip
ref pol rise
sync pol fal

[mfalah]

Hi guys,
Sorry i didnt know there is a way you can open my capture files in your pcs, is there a software where you can see the ref/ sync capture file? I have indeed saved them and i can upload it for you.

Brother Abdo,
The 360 offset i set for the sync setup not the CRIP, based on the example on the help file where it said if you have 8 teeth on sync divide it by 360 and the result 45 will be the sync offset. On ross there is only 1 tooth so I don't know if i am wrong here i will do as you advised.

What filter values have people used i used directly ones from the help file and i interpolated the missing values in the table.

[abdo28]

try this setup it think the ref/sync pol is the problem you cant put them
the same the edge pol is very importent you try the setup

[mfalah]

Hi,
I am uploading my tune, extension type which shows the capture is not allowed but i will be more than happy to mail that file to anyone that pleases. I have also the screenshot of the sync position setup so that you can correct me if i am wrong.

[abdo28]

hi this setup is for variable valve timing you don t need to use it
you try to use the setup up that i post but one thing to do is the
cam sync sensor housing you rotate it full clockwise so you have
the adge polarity for ref rise and the sync fall and the using
timing light conform the crip

[mfalah]

Hi brother Abdo,
Tried your settings and unfortunately i couldnt benefit from it. As previously people had been asking, i have zipped the capture for uploading, you can unzip it and it will be right there for you.