4 inputs for EGT sensors

[anasyakoub]

Hi,
I have evo x M800 and I want to connect the 4 EGT sensors via amplifier to plugin M800,
from the pinout manual I found la1 and 2 AT and 1 AV inputs
can I use them ? it will give the same readings ?

[Stephen Dean]

Which external amplifier are you using? does it have a CAN output?

[anasyakoub]

Which external amplifier are you using? does it have a CAN output?

its from Exhaust Gas Technology, it has Quad Channel Thermocouple Converter 0-5v not can

[stevieturbo]

Maybe this might be of use ?

it says it reads 8 thermocouples and transmits data via CAN

http://www.rrrshop.co.uk/8egt2can---8-t ... -403-p.asp

[anasyakoub]

Maybe this might be of use ?

it says it reads 8 thermocouples and transmits data via CAN

http://www.rrrshop.co.uk/8egt2can---8-t ... -403-p.asp

Thanks a lot, I will take a look into this

[anasyakoub]

I have got this device which works fine on its program, but I couldn't get work on M800,
I am using CAN 1 and I have set a custom data set 2, then I have added an EGT graph but it did not work,
do I missed something I have not setup ?

[stevieturbo]

The two CAN configurations would need to match, but not familiar with how either work.

[anasyakoub]

Yesterday I have tried to put the CAN data to E888 receive and set up the input pins setup I could read two of four EGT sensors only,
so now the communication between M800 and the EGT amplifier is working, I just want to receive the data