M84 to PDM30 to turn fans on using the can bus

by **damian** on Wed Jun 17, 2015 7:19 pm

I know I can wire the aux output on the m84 (set as the thermo fan controller) to a switch input on the pdm, however can't this be done over the can bus in some way? And if so step me through how to set it up on each side?

Appreciate any suggestions, thanks!!

by **Stephen Dean** on Thu Jun 18, 2015 11:17 am

Hi Damian,

These are the CAN Address for the M84 into the PDM, whilst there is not a Coolant fan request message, you can use the Engine Temp value to trigger the coolant fans.

by **damian** on Sat Jun 20, 2015 12:53 pm

Excellent, thanks!!

by **super7** on Sat Oct 03, 2015 4:51 am

What is the CAN address for M400 in the PDM

Sincerely, Nils-Erik

by **Stephen Dean** on Mon Oct 05, 2015 8:50 am

Hi Nils-Erik,

Are you after the receive template for the CAN messages into the PDM?

by **super7** on Mon Oct 05, 2015 7:14 pm

Hello.

Yes like in the previous post in this thread.
Helping a guy to start up his Corvette on which it sits
a M800 and PDM15. Then I'm thinking about buying a PDM15
to my own car, and there sits a M400.

Sincerely, Nils-Erik

M84 to PDM30 to turn fans on using the can bus

M84 to PDM30 to turn fans on using the can bus

Re: M84 to PDM30 to turn fans on using the can bus

Re: M84 to PDM30 to turn fans on using the can bus

Re: M84 to PDM30 to turn fans on using the can bus

Re: M84 to PDM30 to turn fans on using the can bus

Re: M84 to PDM30 to turn fans on using the can bus

Who is online