I am wiring an M150 to one of our customer's rally car, and its got an AIM MXL2 dash. I didn't find information on the AIM website regarding the connection to the M150, only the "older" systems. Anyones got info on that?
Thanks!
M150 to AIM MXL2
4 posts
• Page 1 of 1
Re: M150 to AIM MXL2
by David Ferguson on Tue Jun 02, 2015 8:16 am
What info do you need?
You connect CAN Hi/+ & Lo/-, and in AiM Race Studio 3, select ECU Manufacturer = Motec, and Model = M1.
The MXL2 does not have a CAN terminating resistor, so you'll need to terminate your CAN bus appropriately.
You connect CAN Hi/+ & Lo/-, and in AiM Race Studio 3, select ECU Manufacturer = Motec, and Model = M1.
The MXL2 does not have a CAN terminating resistor, so you'll need to terminate your CAN bus appropriately.
David Ferguson
Veracity Racing Data
Veracity Racing Data
- David Ferguson
- Pro User
- Posts: 1362
- Joined: Fri Nov 07, 2008 2:45 am
- Location: Paso Robles, California
Re: M150 to AIM MXL2
by yorl on Wed Aug 05, 2015 5:05 am
That was it, the resistor. Didn't know if it needed one or not. Thanks
- yorl
- Posts: 13
- Joined: Mon Apr 26, 2010 9:27 pm
Re: M150 to AIM MXL2
by David Ferguson on Wed Aug 05, 2015 6:06 am
Thanks for letting us know what was needed. Good luck with your project.
David Ferguson
Veracity Racing Data
Veracity Racing Data
- David Ferguson
- Pro User
- Posts: 1362
- Joined: Fri Nov 07, 2008 2:45 am
- Location: Paso Robles, California
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 56 guests