help, wideband lambda table and cam control table

[sebastian]

Hi, Please excuse my limited English!
I am starting working a "SUBARU IMPRESA 07",has installed "MOTEC 800"
I have no experience in this type of "ECU", I'm learning.
which are the values of lambda table "lpn ma".
as calculated?
and the values of the table cam control, are the degrees of camshaft?
attached tables.
thanks, regards!!

[Scott@FP]

La Ipn A is the Lambda Characteristic table, mA pump cell output to La value. 0 mA = La 1.0, - mA = rich, + mA = lean.
Not normally a need to change this table.

Yes, cam control target table in 'degrees'.

[sebastian]

La Ipn A is the Lambda Characteristic table, mA pump cell output to La value. 0 mA = La 1.0, - mA = rich, + mA = lean.
Not normally a need to change this table.

Yes, cam control target table in 'degrees'.

thank Scott for your interest!
I have another question, these degrees is crankshaft? values "-" retard and "+" advance cam?
thanks regards!

[Scott@FP]

Yes, usually '0' is indexed to the full retard position on intake cam.

La Ipn A is the Lambda Characteristic table, mA pump cell output to La value. 0 mA = La 1.0, - mA = rich, + mA = lean.
Not normally a need to change this table.

Yes, cam control target table in 'degrees'.

thank Scott for your interest!
I have another question, these degrees is crankshaft? values "-" retard and "+" advance cam?
thanks regards!

[sebastian]

Yes, usually '0' is indexed to the full retard position on intake cam.

La Ipn A is the Lambda Characteristic table, mA pump cell output to La value. 0 mA = La 1.0, - mA = rich, + mA = lean.
Not normally a need to change this table.

Yes, cam control target table in 'degrees'.

thank Scott for your interest!
I have another question, these degrees is crankshaft? values "-" retard and "+" advance cam?
thanks regards!

Hi Scott, know where I can get more information about it? some book?
Thanks regards!