Connect tyre temp sensors by CAN to ADL3

by **gust0214** on Mon May 09, 2011 11:21 pm

We buy two texense sensors IRN8 (tyre temperature in 8 points) this sensors need CAN connection we have connected in CAN 1 the beacon when I use. Is possible that you give me the steps to connect this sensors and setup the CAN?

We wait your response to soon as possible

by **JamieA** on Wed May 11, 2011 10:11 am

can you please send me the documentation on this unit, so that I can look at how we can set it up.

regards

jamie.

by **gust0214** on Wed May 18, 2011 12:46 am

Dear Jamie

I send you the data sheet of this sensors

thank you for your help

by **gust0214** on Mon May 30, 2011 11:07 pm

Dear Jamie

any news for me

i wait your response to soon as possible

by **OmarK** on Mon Jul 18, 2011 11:07 am

Hi,

Attached is the default CAN comms template for the Texense IRN8 sensor for use in SDL3 and ADL3 via CAN. Load this into a spare CAN template in the Communications Setup. The template was made a few years ago but should still work, let us know how you go...

by **mangel83** on Fri Nov 09, 2012 5:12 am

Hi Omar,

Would you happen to have the CAN comms template for the Texense IRN4 sensor for use in ADL2?

by **OmarK** on Mon Nov 26, 2012 12:07 pm

From what I have heard from Texense, the IRN4 is the same as for IRN8 with only 1 CAN ID used for the 4 channel sensor.

Connect tyre temp sensors by CAN to ADL3

Connect tyre temp sensors by CAN to ADL3

Re: Connect tyre temp sensors by CAN to ADL3

Re: Connect tyre temp sensors by CAN to ADL3

Re: Connect tyre temp sensors by CAN to ADL3

Re: Connect tyre temp sensors by CAN to ADL3

Re: Connect tyre temp sensors by CAN to ADL3

Re: Connect tyre temp sensors by CAN to ADL3

Who is online