Edited Post, Lambda reading not showing true value

[benntrevv]

Hey guys,

So I’ve edited the post as I’ve figured out most of it.

Im running a link G4X ecu on my evo 8 and the only sensor that I can’t get to show the proper reading in the lambda.

On the link ecu it’s showing 14.2 and on the Motec c125 dash it’s showing 10.2

I’ve tried going into can communications and playing the the add and multiplayer which is what i used to get all my other sensors reading properly but I’m having no luck with the lambda, any ideas as to why it’s reading 10 on the c125 dash when it’s actually reading 14 on the ecu?

Config and dc file attached

Cheers
Ben

NEW link Dash Config.c125v64

(1.34 MiB) Downloaded 1079 times

New link Dash Display Creator.dcproj

(2.96 MiB) Downloaded 227 times

[Stephen Dean]

Replied to in Support.

[benntrevv]

Main posted edited, for some reason I can’t get the lambda to show a true reading?

[Anthony]

Can you share the link tune file or at minimum a screenshot of the settings for the lambda can transmit?

[benntrevv]

Can you share the link tune file or at minimum a screenshot of the settings for the lambda can transmit?

I’ve sorted it

I had to change the reading on the Motec from lambda to gasoline AFR, and I had to also change the multiplier in can communication for the Chanel down from 1000 to 100.


Ben