MoTeC Global Forum

Hello，
Now I have a C185 Dash manager and a M800 ECU ，but I have some problems in sending CAN messages from C185 to M800 ECU.
How can I set up my C185 and ECU? Thanks!

Hi,

What sort of messages are you wanting to transmit to the M800? Can you upload the configurations thanks.

Stephen Dean wrote:Hi,

What sort of messages are you wanting to transmit to the M800? Can you upload the configurations thanks.

Hello,
These are my configurations. But in the M800, only ExA1, ExA2, ExA9 and ExA10 display data.

You should set the CAN2 Data to 4 (ADL receive -- the C185 is a relative of the ADL), and follow the help instructions for how to format your C185 messages.

Actually, you should do what Stephen suggested and post your complete configs, that way someone could fix them for you.

David Ferguson wrote:You should set the CAN2 Data to 4 (ADL receive -- the C185 is a relative of the ADL), and follow the help instructions for how to format your C185 messages.

Actually, you should do what Stephen suggested and post your complete configs, that way someone could fix them for you.

OK. This is the configuration file for my C185. Is there any problem with it? Thanks!