MoTeC Global Forum

Hello!

Few days ago I bought car with MoTeC looms, ECU, PDM, Dash, etc.

We have all working on version 6.10 dashboard. Due to our lack of knowledge how to work with that, I downloaded from official website dash manager 6.40. When I connect to car and want to download telemetry I recived message "need to update software" and I press "YES" without reading. Now I know it was the most stupid what I made.. My car stop to work. But I have backup software from my dashboard. One of my friend which are working with MoTeC, told me "made downgrade software to 6.10" and then send that file again and should work. I made it. Now my dashboard are 6.10 same as I have backup file. But when I want send configuration to my dashboard I recived information if I can't do it due to non calculations - photos down. Can anyone try to help me how to repair it and make car "working" again?

https://files.fm/u/3ycxbxe83#/view/6bmsne6ef - here is message which are back when want to send it to dashboard.

Best Regards
Bartek

It is reporting that channels in the configuration are being used for functions - such as logging for the top channel shown.

There are few possible reason for this, either templates have been removed in your backup file, or if the original file was generated on another laptop, certain channels might not match up correctly using the config on another laptop due to a differences in channel lists stored on the laptop.