MoTeC Global Forum

Hi all,

Ive been trying to see if Motec CAN will support CANopen on the C185 dash. I've found a thread that barely mentions CANopen, but doesnt go into any detail on what Motec supports. Any information regarding CANopen will be very helpful here.

The purpose for communication is to log data from an electric motor controller (EMSISO EMDrive 500) that has warning flags, and output data sent over CANopen.

Hi drewmccoo,
What component of CANOpen specifically are you after support on?

The keypads and rotary dials are CANOpen devices and can be configured and controlled from the dashes with no issues.

If you can outline exactly what you are trying to achieve, it will make it easier to give you a specific answer.