M1 with Fuel Tech EGT Kit

Support forum for users of the M1 Tune

M1 with Fuel Tech EGT Kit

Postby ammar.alqisie30 on Tue Jun 18, 2024 8:35 am

ammar.alqisie30
 
Posts: 22
Joined: Mon Jul 03, 2023 9:42 pm

Re: M1 with Fuel Tech EGT Kit

Postby NathanB on Tue Jun 18, 2024 9:10 am

Hi,

No it is not able to be used with the M1 ECU with any off the shelf firmware.
NathanB
MoTeC
 
Posts: 198
Joined: Thu Oct 15, 2020 1:50 pm

Re: M1 with Fuel Tech EGT Kit

Postby ammar.alqisie30 on Wed Jun 19, 2024 10:12 am

Can connect them directly to E888 ?
ammar.alqisie30
 
Posts: 22
Joined: Mon Jul 03, 2023 9:42 pm

Re: M1 with Fuel Tech EGT Kit

Postby Stephen Dean on Wed Jun 19, 2024 11:58 am

The E888 can be used with the M1, and it can take up to 8 K Type Thermocouples. You need to remove the yellow connector and crimp the E888 pins onto the wires to use it.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
Stephen Dean
Site Admin
 
Posts: 1645
Joined: Tue Dec 02, 2014 10:29 am
Location: Melbourne

Re: M1 with Fuel Tech EGT Kit

Postby Niklas Sandstrom on Wed Jul 17, 2024 3:02 am

Is it possible to use an C127 to translate the CAN signal?
Niklas Sandstrom
 
Posts: 10
Joined: Sat Jan 12, 2019 3:30 am

Re: M1 with Fuel Tech EGT Kit

Postby David Ferguson on Wed Jul 17, 2024 9:44 am

That looks possible. You would create a CAN Comms Template for the C127 using the information on page 26 of the protocol manual. Then you would send that on to your ECU bus, and fill in some of the CAN X offset Y parameters. These resources would be configured for the M1 Exhaust Temperature Sensor Resources.
David Ferguson
Veracity Racing Data
David Ferguson
Pro User
 
Posts: 1348
Joined: Fri Nov 07, 2008 2:45 am
Location: Paso Robles, California


Return to M1 Tune

Who is online

Users browsing this forum: No registered users and 9 guests