The computer cannot connect to the M150

Support forum for users of the M1 Tune

The computer cannot connect to the M150

Postby XXY on Wed Apr 24, 2024 6:47 pm

I have an M150, when I use Ethernet to connect the M150 to my computer, the Quick Launch says my M150 has been detected, but when I use the mouse to click on the ECU icon, it keeps stutting, I have turned on IPV6, and my computer can turn on C125 normally.
I think there's something wrong with my computer because I can turn it on when I use my friend's other computer.
I am very upset because I can't use M150 normally, so I would like to ask about the possible problems of my computer, thank you!!!
My English is not very good, maybe the expression is not very good, excuse me.
Attachments
mmexport1713943349455.jpg
mmexport1713943349455.jpg (1.07 MiB) Viewed 476 times
Snipaste_2024-04-24_15-31-42.png
Snipaste_2024-04-24_15-31-42.png (280.9 KiB) Viewed 476 times
XXY
 
Posts: 5
Joined: Mon Apr 15, 2024 6:40 pm

Re: The computer cannot connect to the M150

Postby Stephen Dean on Fri Apr 26, 2024 11:02 am

Hi,

In M1 Tune, can you go to View | Show Messages and View | Show ECU Monitor, and clear each of the windows that come up by right clicking on the window and selecting Clear. Once this is done, try to connect to the ECU again and then copy the messages that are posted in the two windows. Paste these into a document and then sent it through to support @ motec.com.au
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
Stephen Dean
Site Admin
 
Posts: 1641
Joined: Tue Dec 02, 2014 10:29 am
Location: Melbourne

Re: The computer cannot connect to the M150

Postby XXY on Fri Jun 07, 2024 12:49 am

Okay, I've successfully connected to the M150, thank you!
I would like to ask where is the basic control of biased ignition in the M150
XXY
 
Posts: 5
Joined: Mon Apr 15, 2024 6:40 pm


Return to M1 Tune

Who is online

Users browsing this forum: No registered users and 2 guests

cron