M130 GPLite map switch
Posted: Mon Jan 01, 2024 3:45 pmAnyone familiar with the GPLite ECU? I'm wondering if I can use an ethanol content sensor on pin B6 which is pre-assigned as Map Switch?
MoTeC Global Forum
The official support forum for MoTeC products
https://forum.motec.com.au/
M130 GPLite map switch
Page 1 of 1
Posted: Mon Jan 01, 2024 3:45 pmRe: M130 GPLite map switch
Posted: Tue Jan 02, 2024 9:34 amPin B6 on the M130 is an Analogue Temperature (AT4) input, this is not the type of input that will recognise the digital signal from the Ethenaol Content sensor.
Re: M130 GPLite map switch
Posted: Tue Jan 02, 2024 8:06 pmYou would need to use a "UDIG" pin, so B8/9/10/11/14