MoTeC Global Forum

ECU ??

Serial 9109020 P/N CEM-3D-M
EPS 3.3 C4


Is it possible to connect this calibrator and black box to the M4 with ser. no. <3000?

I can't believe!

ECU is still alive! Calibration box is working, PC connection running EMP3V3 on XP is also OK. FW version is 3.21

Is there any documentation still available?

That is a very old 2 Group ECU. DOcumentation is very limited but I have attached a scan of the hand controller manual. THe wiring drwing can be downloaded from the MoTeC web site http://www.motec.com.au/downloads/downloaddatasheets/.

WOW, I would like to have a look inside the circuit in the transmit modem. Are you able to post a photo of the circuit? I need to make on of these that works.