M4 Gear Detection

[Taylor]

I have my VSS(digital signal) to DIG 1input and selected as Speed Measure.

I have Gear Sensor Source set to Dig 1.

I have all the correct gear ratios, final drive(via factory specs), teeth count and calibrations set, and matchs my speedo on the dash +/-1 mph.

When looking at the sensor view(V) It reads "speed", but does not display which gear I am currently in. It reads 0 as my gear selected.

Is this only available through advanced functions?

[RossB]

It sounds like you have done everything. Can you post your configuration and let me know your tyre circumference?