Not Displaying Properly

Discussion and support for discontinued MoTeC ECUs, including M8

Re: Not Displaying Properly

Postby kotaro-jpn on Mon Oct 07, 2024 10:56 pm

After that I tried various display drivers but there was no improvement.
The results were the same even when I used the standard Windows driver.

What I'm wondering is that when I use my PC with multiple monitors
the PC works with multiple monitors on the adjustment screen and setup screen
but when I press "G" on the adjustment screen to display a graph it no longer works as a multi-monitor and only the laptop screen is active and there is no signal input to the sub-display.
It is certain that some conditions change only when I press "G" to display the graph screen.
kotaro-jpn
 
Posts: 8
Joined: Tue Sep 17, 2024 5:49 pm

Re: Not Displaying Properly

Postby Stephen Dean on Tue Oct 08, 2024 3:26 pm

The problem is that you are using a 8bit program, in a 16bit subsystem on a 32bit operating system. There is a link somewhere along the chain between the program and the video driver that is not working correctly thus the graphics not displaying correctly.
Stephen Dean
MoTeC Research Centre Melbourne, Australia
User avatar
Stephen Dean
Site Admin
 
Posts: 1726
Joined: Tue Dec 02, 2014 10:29 am
Location: Melbourne

Re: Not Displaying Properly

Postby kotaro-jpn on Mon Oct 14, 2024 4:18 am

Thanks for the tips. I'll give it a try.
kotaro-jpn
 
Posts: 8
Joined: Tue Sep 17, 2024 5:49 pm

Previous

Return to Old ECUs

Who is online

Users browsing this forum: No registered users and 6 guests